A lot of people have been telling me that I should add RFID to my engine start button project. That’s exactly what I did. I’m using an Arduino Nano connected to a RC522 RFID reader/writer. When the Nano recognizes a scanned RFID tag, it sends a code via serial to the ATMega328 that controls the ignition/accessories/starter motor. When the ATMega328 receives the code, it enables the engine start functionality. If no RFID tag is scanned or if an incorrect tag is scanned, pressing the engine start button will not start the engine.
Tag Archives: mod
Start Button Update
Here are some photos that I took while everything is wired-up in my car.
How to Install a Start Button
Here’s the best low-cost way to put a fully functional engine start button in your car! Absolutely no key needed to start your car! Just press the button and go!
You may have seen others put engine start buttons in their cars, but they still had to use a key! It’s like, “really, guys? You’re adding a step to starting your car“! You definitely don’t want to be like those idiots. You, you’re much smarter than those hook-it-straight-to-the-starter guys. You know there’s gotta be a better way… and there is!
Continue reading How to Install a Start Button
Make a 5V Power Supply For Arduino From a Car USB Charger
This is what I did to power the Arduino which I used in my engine start button project. It’s a simple and cheap way to power an Arduino in a car. This will requires some basic soldering skills.
But a simple USB charger – the kind that plugs into your car’s power outlet. They usually cost ~$2-5(USD). You can probably find them at most convenience stores, or maybe a box store of your choice.
Continue reading Make a 5V Power Supply For Arduino From a Car USB Charger
Start Button Install Progress (part 1)
The first place that I was going to install the button was in the larger hole cover that covers the hole in the dash where accessory switches go, but were not used. However, I found a better location while solving the steering lock issue. The key cylinder also operates the steering lock, but if I’m not going to use the key to start the car, the steering lock just inconveniences me. I had to remove it.
Start Button in Car Test
After adding the relay module and start button, as well as making some changes to the code, I wired my test circuit up to CRX to see if it could actually work. Video below…
Start Button Update 2
I recently purchased a 4 channel relay module and a start button from a Mazda 3. The relay module cost me $8.49(USD) from Sain Store on Amazon.com. The Mazda 3 start button cost $25.00 off ebay.
Start Button Update 1
I wrote a program for the Arduino, and put together a test circuit to see if it would work. I used LEDs to show the functions. I wrote 6 different versions of the code until I finally came up with one that worked exactly how I wanted. I’m not a programmer, so this code is rather sloppy, and I’m sure there’s a much better way to do this, but, hey, it works.
I’ll post the code later, after I make the final version.